Filter
Top Products
1
2
3
4
5
3-3E
– Loosen retaining bolt on tank 1 and remove from tank together with
the rubber grommet.
– Lift tank from the frame.
– Open chain joint
2 and remove chain.
– Loosen hose clamp
3 of the intake flange on the carburetor, pull
carburetor back and swing to the side.
NOTE: if the carburetor is not being serviced, it does not need to be
removed - the carburetor openings should however be covered with a
clean cloth and the gasoline drained from the float chamber.
– Remove radiator shield on the right and left
4.
– Unbolt radiator cap, open drain plug
5 and allow cooling fluid to
drain into a receptacle. Then remount the drain plug with a new
sealing ring and tighten (5 Nm/4 ft.lb).