Filter
Top Products
Contents
Page
Safety.......................................................... 051
Getting Started
Theory of Operation............................................101
Making Implement Guidance Function...............102
Accuracy.............................................................102
iGuide Activation.................................................103
Useful Buttons and Icons....................................103
Setup
Getting Started ...................................................151
Machine Setup....................................................152
Machine Offsets..................................................154
Implement Setup ................................................156
Implement Offsets ..............................................158
Implement GPS Offsets....................................1510
Measuring in line dimension from
receiver to receiver.......................................1510
Receiver Installation .........................................1511
GPS Receiver Setup ........................................1512
TCM Calibration................................................1515
Guidance Setup................................................1517
Operation
Operation of iGuide ............................................201
Integrating iGuide and iTEC Pro
Hardware and Software Requirements ..............251
Hardware and Software Requirements ..............251
Setup ..................................................................251
Operation............................................................252
Using Implement Receiver
forDocumentation and Coverage Map ...........253
Tuning Guide
Setting Up Vehicle Offsets..................................301
Setting Up Implement Offsets.............................302
Setting Up Implement GPS Offsets ....................302
Tuning Slope Compensation ..............................304
Tuning iGuide Sensitivity....................................304
Troubleshooting
Troubleshooting Tips ..........................................351
Valid Configuration .............................................352
Specifications
Metric Bolt and Screw Torque Values.................401
Page
Unified Inch Bolt and Screw Torque Values........402
Original Instructions. All information, illustrations and specifications in this
manual are based on the latest information available at the time of publication.
The right is reserved to make changes at any time without notice.
COPYRIGHT © 2009
DEERE & COMPANY
Moline, Illinois
All rights reserved.
A John Deere ILLUSTRUCTION ® Manual
i
102110
PN=1