Filter
Top Products
CONVENIENCEGETTING STARTED DRIVING CONTROLS COMFORT MEDIA CENTER NAVIGATION
convenience
39
Alternate Command Mode
For advanced operation, you can change to an
Alternate Command Mode that expands the avail-
able list of commands. When this mode is active,
all the Phone, Navigation, Information, Audio and
Help commands can also be spoken after pushing
the
switch without fi rst having to say the type of
command (e.g., Phone).
To Turn ON Alternate Command Mode:
1 Press the SETTING button.
2 Select the “Others” Key.
3 Select the “Voice Recognition” Key.
4 Select the “Alternate Command Mode” Key.
When the Alternate Command Mode is ON, perform the Speaker Adaptation procedure to train
the system to your voice. Refer to the 2010 INFINITI Navigation System Owner’s Manual for
detailed information on Speaker Adaptation and use of the Alternate Command Mode.
Automatic Drive Positioner Memory System –
Driver’s Seat, Steering & Outside Mirrors
(if so equipped)
When programmed, the Automatic Drive Positioner can
adjust the driver’s seat, steering column and outside mirrors
to two memorized positions.
To Set Customized Seat, Steering and Mirror Position Memory:
1 Push the ignition switch to ON mode. Keep the transmission in P (PARK).
2 Adjust the seat, steering wheel and outside mirrors to the desired positions.
3 Press the SET button. The indicator lights on both Memory buttons 1 and 2 will illuminate.
4 Within 5 seconds, press Memory button 1 or 2 and hold down for at least 1 second.
The indicator light on the Memory button you select will illuminate for approximately
5 seconds. Seat/steering/mirror memory is now set to your preference.
5 Link the seat/steering/mirror memory to your INFINITI Intelligent Key.
While the indicator light on the Memory button is illuminated (see step 4, above),
press the UNLOCK button on your Intelligent Key. The indicator light on the Memory
button chosen will blink ON and OFF approximately ten times. The memory is now
matched to the Intelligent Key. You may set the second seat/steering/mirror memory
positions to your other Intelligent Key by repeating the steps above.
Note: After step 5 is performed one time to link the seat/steering/mirror memory to your Intelligent Key, you DO NOT
need to perform this step again if new seat/steering/mirror memory positions are saved in the future. New memory
positions are automatically linked to your Intelligent Key after step 5 is performed one time.