Filter
Top Products
Introduction
vii
Getting Started
Garmin USB Cable
DO NOT connect the Garmin USB
cable to your computer until you have
followed the instructions in the Setup
Guide. Garmin-specific drivers must
be installed on your computer before
you connect the USB cable to your
computer.
Note:
This manual assumes that you have transfered maps to your StreetPilot. If you do not download City
Navigator maps to your StreetPilot, you will not see some of the information or features described
throughout this manual. Additionally, you will see minimal detail of major roads and highways on your
StreetPilot.
Step 3:
Try out your StreetPilot! Use the Tutorial on page vi to learn how to find a nearby restaurant and create
a route to it. In addition to your StreetPilot, you will need the following items that are included in the
StreetPilot package:
• Vehicle adapter. This is a 12/24 volt DC adapter with an external speaker system that connects
to your vehicle and your StreetPilot.
• Dash mount or portable bean bag mount. If you would like to mount your StreetPilot to your
vehicle right away, see the instructions on page 61.
Once you complete these three steps, you will be set up and ready to enjoy the full operation of the
StreetPilot!
Further Recommendations:
Read the StreetPilot 2610/2650 owner’s manual to learn how to create routes that include multiple
destinations, how to specify areas or road segments to avoid when calculating routes, and how to use a
variety of other exciting features.
Read the MapSource owner’s manual to learn how to create routes and waypoints on your computer
and then transfer this information to your StreetPilot.