Filter
Top Products
Preparing
for the
Trip
Before you navigate a trip, determine whether you will fly
direct to a waypoint, or navigate a route of several
waypoints. This tutorial presents instructions to set up either
kind of trip. It may be helpful to first navigate direct to a
destination before setting up a route to travel.
Originating
the Trip
The Precedus‘s simulator uses your present position as the
point of origin for the trip unless you have already used the
unit to navigate a route. If this is the case, refer to the tutorial
section entitled “Navigating a Route” later in this section, or
deactivate your route and continue. These exercises assume
your present position is the point of origin for the trip.
Assigning a
Direct
Waypoint
1. Press the button.
2. Press buttons to select the
first character of the destination
waypoint name.
3. Press the button to move the
highlight to the next character of your
destination waypoint name.
4. Repeat steps 2 and 3 to select the last
character of the destination waypoint
name and the waypoint type. Press the
button to assign the waypoint as
the destination.