Filter
Top Products
•
OFF - Power light will stay off
•
On When Ext - Power light will turn on when external
power is supplied
•
Flash/Charge - Power light will flash when the battery is
charging
Press to reach the “CONTRAST”
selection. Adjust the display contrast by
pressing the buttons. As
you make adjustments, the horizontal
bar shows the current contrast level.
“ - ” indicates lower contrast, while “ +
” indicates higher contrast. The contrast
setting you select is stored in memory
and remains in effect until you change
it.
Time
and Place
Use this function to enter your present position and set UTC
and local times. It is necessary to enter the time and place the
first time the Precedus is switched on; this is called the
“Seed Position.” Time and place information you enter is
stored in memory and need not be entered again. However, it
is necessary to enter this information again if the unit is
switched off and moved a distance of several hundred miles
or more.
In the Main Menu press, or
to highlight “TIME & PLACE” and
press . The Lat/Lon position will
be highlighted. Press the
buttons to highlight each character to
change and press the buttons
to select the desired value. Repeat this
operation for all necessary values.
System
Setup
This function sets the Precedus operation mode (USAGE),
Serial I/O, and the number of NAV Information pages
available in the NAV function.
There are six operating modes (USAGE) available in the
Precedus.