Filter
Top Products
7
Getting Started
Section 2
The Quick Set List of Options
Keyguard On message appears whenever a key is pressed.
GPS On and Off Messages
The Mark Waypoint Page
Keyguard
“Pop-Up”
Window
Press and Hold the
CLEAR key to Disable
Using the ‘Quick Set’ Feature
The Quick Set feature allows you to quickly activate some basic opera-
tional characteristics of your unit such as Keyguard, Profiles (unit ringer
volume and call answer modes), GPS On/Off, and Mark Waypoint features.
Using the Keyguard Feature
The ‘Keyguard’ feature allows you to lock the keypad to prevent
inadvertent pressing of a key while the unit is in your pocket, purse, etc.
This prevents accidental placement of one keypress dialling options such
as speed dial and emergency dialling. Press and Hold the ENTER key
to display the Quick Set Menu, use the ARROW key to highlight the
‘Keyguard’ option and press ENTER again to activate this feature. When
‘Keyguard’ is operational, a message will appear each time a key press is
attempted. Press and Hold the CLEAR key to cancel ‘Keyguard’. Incom-
ing calls and messages will temporarily unlock the keypad.
Synchronizing Contact Data (Begin Sync)
(Applies only to units provided with the Intellisync for GARMIN CD-ROM)
To begin synchronizing PC contact program data using Intellisync for
GARMIN, highlight this option and press ENTER. Refer to page 109.
Turning the GPS Receiver On or Off
To turn the GPS receiver On or Off, highlight the GPS Off/On option
and press ENTER. When On the receiver will significantly reduce the
battery reserve. When Off, it will allow extended battery use.
Marking Your Current Location (Mark Waypoint)
The Mark Waypoint feature allows you retain a record of your cur-
rent location and save it as a waypoint which can be used as a destina-
tion when creating a route. Highlight the Mark Waypoint option and
press ENTER to display the Mark Waypoint page. Use the ARROW key
to highlight the ‘OK’ button and press ENTER to save the waypoint.
Refer to page 87 for more information.
Using the ‘Quick Set’ Feature
‘Mark Waypoint’
Option will appear
gray if GPS is not
active or searching
for satellites.
NvTlkGSMManual copy.indd 7 12/2/2002, 8:41:53 AM