Filter
Top Products
• Setup Page Display?— allows you to specify the number of fields
displayed in the data window section of the map page. A graphic
compass tape or CDI scale may also be displayed. The following options
are available:
• 2 Fields • 2 Fields& Compass
• 2 Fields & CDI • 4 Fields
• 4 Fields & Compass • 4 Fields & CDI
• 6 Fields • 6 Fields & Compass
• 6 Fields & CDI • 8 Fields
To select a page display option:
1. Highlight the ‘Setup Page Display?’ option and press T.
2. Select the desired option and press T.
• Change Data Fields?— allows you to specify the data displayed in
each data field used on the map display. The following options are available:
• BRG- bearing to active wpt • DIS- distance to active wpt
• SOG- speed over ground • COG- course over ground
• ETE- estimated time enroute • ETA- estimated time of arrival
• XTK- crosstrack error • VMG- velocity made good
• TRN- turn angle to wpt • WPT- active wpt name
To change a data field:
1. Highlight the ‘Change Data Fields?’ option and press T.
2. Move the field highlight to the desired field and press T.
3. Select a data field option and press T.
• Restore Defaults?— resets all map page options (except map
configuration options; see pages 33-34) to the factory settings.
• Setup Simulator?— allows you to define speed, course and position
values while in simulator mode. See the Getting Started Tour for more
on using simulator mode.
MAP PAGE
Page Display & Data Fields
A. The map page can be
configured to display
a variety of
navigation data.
B. Each data field can
be set to display one
of ten data options.
35
3
175 Manual 7/31/98 3:56 PM Page 35