Filter
Top Products
eTrex HC series Owner’s Manual 25
MaIn paGeS
Position mode pans the map to keep your present
location in the display area. The position marker
shows your travel on the Map page.
When you press the ROCKER, the eTrex enters pan
mode, which moves the map to keep the white arrow
(map pointer) within the display area. Add and
configure up to four optional data fields at the top of
the page to provide a varity of travel and navigational
information.
To show data elds on the Map Page:
1. Press MENU > Data Fields. The Show sub-
menu appears.
2. Select the number of data elds you want to
show on the Map page, and press ENTER.
To change a data eld display:
1. Press MENU > Change Data Fields. The rst
data eld is highlighted.
2. Press ENTER.
3. Select an option.
4. Move to the next eld, and repeat.
Using Additional Map Data
View listings of nearby restaurants, lodging, shopping
centers, attractions and entertainment, and retrieve
addresses and phone numbers for any listed location
when using optional MapSource data disks and pre-
programmed microSD cards.
To review map information:
1. From the Map page, press MENU > Setup
Map.
2. Select the Map Setup-information page. The
list of maps stored appears. A check mark
means the map is shown on the Map page.
Changing the Zoom Range
Press the In key to decrease the zoom range and
show an area with greater detail; press the Out key to
increase the range to see a larger area with less detail.
The current zoom range setting is shown in the
lower-left corner of the Map page. If no further map
information is available, “overzoom” appears under
the zoom range. When using MapSource maps,
“mapsource” appears below the scale.