Garmin 3206 GPS Receiver User Manual


  Open as PDF
of 130
 
102 GPSMAP 3206/3210 Owner’s Manual
aPPendIX > InstallIng and reMovIng data cards
appendIX
Installing and Removing Data Cards
The GPSMAP 3206/3210 uses optional preprogrammed Garmin BlueChart
®
g2™
and MapSource
®
data cards. Insert data cards in the card slot located on the left
side of the unit. Data cards can be installed or removed at any time, whether the
unit is on or off.
To install a data card:
1. Openthecarddoorbypressingthelockingtabonthedoortowardthe
outside(left)oftheunitandliftingthedooropenfromrighttoleft.
2. Insertthecardintotheslot,withthelabelfacingtotherightandthehandle
towardyou.
3. Pushthecardintotheunit.Itinnotnecessarytoforcethecard,and
about1/2"isstillexposedwhenitisproperlyinserted.Iftheunitison,a
conrmationtonesounds,andamessageappearsonthescreennoting
thecarddetailswhenthecardisproperlyinstalledandaccepted.
4. Closethecoveruntilitlocks.
If you insert a data card and receive a “card format not recognized” message,
remove the card and reinsert it. If the card is still not recognized, contact Garmin
Product Support or your Garmin dealer for assistance.
NOTE: Data cards are not waterproof, should not be exposed to moisture or
excessive static charges, and should be stored in the case supplied with the
card. Data cards are a Garmin proprietary device and are not interchangeable
with the SD cards used for Garmin g2 Vision mapping data.
The rst time you insert a data card, the unit takes a few seconds to read the
card. After the data card is read, a summary page appears. Press ENTER to
acknowledge.
To remove a data card:
1. Openthecarddoorbypressingthelockingtabonthedoortowardthe
outside(left)oftheunitandliftingthedooropenfromrighttoleft.
2. Graspthecardhandle,andpulloutrmly.
3. Iftheunitison,aconrmationtonesoundswhenthedatacardisremoved.
 previous next