Filter
Top Products
10. INSTALLATION
10-12
Setting DATA 4 to "COM." (general data)
Waypoint data can be received from a personal computer, through the DATA 4
port.
1) Press [MENU ESC], [9] and [5].
2) Press
to select Level.
3) Press
or to select level of personal computer; RS232C or RS422.
4) Press the [CU/NU ENT] key.
5) Press
or to select Com.
6) Press
to select To Next Page. The DATA 4 I/O SETUP <Com.> menu
appears.
Loading erases current data
Are you sure to load?
ENT: Yes MENU: No
Figure 4-4 DATA 4 I/O SETUP <Com.> menu
7) Press
to select Baud Rate.
8) Press
or to select baud rate; 4800bps, 9600bps, or 19200bps.
9) Press the [CU/NU ENT] key.
10) Press
to select WPT/RTE.
11) Press
to select Command. Stop, on the same line as Command, appears
in reverse video.
12) Press
to select Start. The message shown in Figure 4-5 appears.
Now loading
WPT/RTE data !
MENU: Stop
Figure 4-5
13) Press the [CU/NU ENT] key. The message shown in Figure 4-6 appears
while data is being loaded.
Are you sure to stop ?
ENT: Yes MENU: No
Figure 4-6
14) Output data from the computer. When data is loaded, the cursor shifts to
Stop.
15) Press the [ESC] key.