Filter
Top Products
2. DISPLAY AND TRACK
2-5
2.9 Apportioning the
Memory
The memory holds 2,000 points of track and
marks and may be apportioned as you like.
The default memory setting stores 1,000
points each of track and marks.
Note: All data are erased when the memory
apportion setting is changed, even
when the previous value is reentered.
To store 1,500 points of track and 500 marks,
for example, do the following:
1) Press the [MENU ESC] key.
2) Press [9] to display the SYSTEM
SETTINGS menu.
2. UNIT SETUP
SYSTEM SETTINGS
1. PLOTTER SETUP
2. UNIT SETUP
3. DATA 1, 3 OUTPUT SETUP
4. DATA TRANSFER
5. DATA 4 I/O SETUP
6. GPS SETUP
7. DGPS SETUP
8. LOP SETUP
9. CLEAR MEMORY
2. UNIT SETUP
ENT: Enter
MENU: Escape
Figure 2-8 SYSTEM SETTNGS menu
3) Press [1] to display the PLOTTER SETUP
menu.
PLOTTER SETUP
Bearing Ref.
Auto
(07 W)
Man
(00 E)
ENT: Enter
MENU: Escape
Memory Apportion
Mag Variation
True
Trk = 1000 / 2000Pt
Mag
R.L
G.CCalculation
User defined #1 RNG
User defined #2 SOG
User defined #3 BRG
User defined #4 COG
Figure 2-9 PLOTTER SETUP menu
4) Press
to select Memory Apportion.
5) Enter amount of track to store, in four
digits. To store 1,500 track points, for
example, press [1] [5] [0] [0].
6) Press the [NU/CU ENT] key, or
or .
You are asked if it is all right to erase all
data.
Setting erases all data!
Are you sure to change ?
ENT: Yes MENU: No
Figure 2-10
7) Press the [NU/CU ENT] key.
8) Press the [MENU ESC] key.
2.10 Bearing Reference
Ship's course and bearing to waypoint may
be displayed in true or magnetic bearing.
Magnetic bearing is true bearing plus (or
minus) earth's magnetic deviation.
True or magnetic bearing
The default setting displays magnetic
bearings.
1) Press the [MENU ESC] key.
2) Press [9] to display the SYSTEM
SETTINGS menu.
3) Press [1] to display the PLOTTER SETUP
menu.
4) Press
or to select Bearing Ref.
5) Press
or to select True or Mag.
6) Press the [NU/CU ENT] key.
7) Press the [MENU ESC] key.