Filter
Top Products
5. SETTING DESTINATION
5-2
Flag
mark
Figure 5-4 Single destination set by cursor
Setting multiple destinations
1) Press [GOTO] and [1].
2) Place the cursor on the location desired
for a waypoint.
3) Press the [NU/CU ENT] key.
4) Repeat steps 2 and 3 to enter other points.
Waypoints are connected with a line.
5) Press the [NU/CU ENT] key to finish. The
route number entry display appears as
shown in Figure 5-5. If no route number
appears or you want to change the route
number shown, go to step 6 to enter route
number. To register the route under the
number shown, go to step 8.
Enter route number
ENT:Enter MENU: Escape
0 1
Figure 5-5
6) Key in route number.
7) Press the [NU/CU ENT] key. Waypoints
are marked with flags and are connected
with a dashed line.
If the route number entered already exists the
message shown in Figure 5-6 appears.
Overwriting ?
ENT:Yes MENU:No
Figure 5-6
8) Press the [NU/CU ENT] key.
The waypoints do not have waypoint numbers,
however you can attach waypoint numbers by
doing the following.
1
Press [WPT RTE] and [5] to display the
route list.
2
Press or to select route number
entered.
3
Press .
4
Enter waypoint number, in three digits.
5
Press . If the waypoint number already
exists the message shown in Figure 5-7
appears.
This waypoint already exists
Are you sure to change ?
ENT:Yes MENU:No
Figure 5-7
6
Press the [NU/CU ENT] key. The waypoint
entered here replaces previously entered
waypoint.
Note: To cancel replacement of
waypoint, press the [MENU
ESC] key at step
6
.
7
Repeat steps
4
and
5
to enter other
waypoint numbers.
8
Press the [MENU ESC] key twice to finish.
When destination is cancelled, dashed lines
are erased but flags remain on the screen.