Filter
Top Products
4. NAVIGATION PLANNING
4-4
_ _
Edit = Waypoint : 001
Mark :
Cmnt :
ENT: Enter
MENU: Escape
: Column
: Cursor
__
_ _._ _ _’ N _ _ _ _ _._ _ _’ W
Figure 4-11
6) Enter latitude and longitude. To enter
34°12.345' N 135°23.456' E, for example,
press;
([ ]) [3] [4] [1] [2] [3] [4] [5]
([
]) [1] [3] [5] [2] [3] [4] [5] [6]
To change N to S or E to W, press [
].
7) Press .
8) Press
or to select mark.
9) Press the [NU/CU ENT] key.
10) Enter comment.
11) Press the [NU/CU ENT] key twice.
The waypoint list reappears. Waypoint
position and date and time the waypoint was
entered appear on the list.
12) To enter another waypoint through the
waypoint list, repeat steps 4-11.
13) Press the [MENU ESC] key to finish.
4.2 Editing Waypoints
Waypoints are mutually edited when the
navigators are sharing data.
1) Press [WPT RTE] and [4].
2) Press
or to select waypoint to
edit.
3) Press
.
4) Edit the contents of the waypoint.
5) Press the [NU/CU ENT] key. The
message shown in Figure 4-12 appears if
the waypoint is currently selected as
destination, is part of a route, or is in the
route currently selected as destination.
This wpt is GOTO
This wpt is in registered route
This wpt is in selected route
1st line
Are you sure to change ?
ENT: Yes MENU: No
Figure 4-12
6) Press the [NU/CU ENT] key.
Enter new data, referring to "4.1 Entering
Waypoints".
7) Press the [MENU ESC] key.
4.3 Erasing Waypoints
Waypoints are mutually erased when the
navigators are sharing data.
Erasing waypoints by the cursor
1) Place the cursor on the waypoint to
erase.
2) Press the [CLEAR] key.