Filter
Top Products
10. INSTALLATION
10-9
Rate of operation
The TX rate or operation is the percentage of data output in one second, and it
appears on the screen. If short intervals are assigned to many sentences, the
rate of operation increases as illustrated below.
TX TX TX
A rate of operation exceeding 100% is impractical.
When the external equipment cannot display correct data input from the
GP-90-DUAL, the rate of operation should be lowered.
For example, set a rate of operation less than 60% for the Temperature Indicator
TI-20.
DATA1 output setting
1) Press [MENU ESC], [9] and [3] keys to show the DATA1, 3 OUTPUT SETUP
menu.
Talker ID GP LC DE
Output Data (00-90 sec)82%
1. AAM:00 APA:00 APB:01 BOD:00
2. BWR:00 BWW:00 GGA:01 GLL:00
3. RMB:01 RMC:01 VTG:01 WCV:00
4. WNR:00 WPL:00 XTE:00 ZDA:01
5. GNS:00 GBS:01 Rnn:00 RTE:00
DATA3. Log Pulse
400ppm
DATA 1, 3 OUTPUT SETUP
MENU : Escape
ENT : Enter
200ppm
Settings shown here are default settings.
This line appears only when LOG is
selected by internal jumper wires.
Data Fmt. V1.5 IECV2.0
Figure 4-1 DATA1, 3 OUTPUT SETUP menu
2) Press
to select DATA FMT.
3) Press
or to select V1.5, V2.0 or IEC.
4) Press the [CU/NU ENT] key. Talker ID appears in reverse video.
5) Press
or to select GP, LC or DE.
6) Press the [CU/NU ENT] key.
7) Enter TX interval for each output data sentence in line 1. TX interval is
available in 00, 01, 02, 03, 04, 05, 06, 10. 15, 20. 30, 60 and 90 msec.
8) Press the [MENU ENT] key.
9) Enter TX interval for each output data sentence in lines 2 through 5. Press
the [CU/NUENT] key after setting each line.