Filter
Top Products
8. MENU SETTINGS
8-4
Time difference
1) Press [MENU ESC], [9] and [6].
2) Press
or to select Time Diff on
page 2/2.
3) Key in time difference (-14:00 to +14:00).
4) Press [
] to change from plus to minus
or vice versa.
5) Press the [MENU ESC] key.
Position
After the unit is installed you may enter
position to shorten the time it takes to find
position. (It takes about two minutes when
there is no position data entered.)
1) Press [MENU ESC], [9] and [6].
2) Press
or to select Posn on page
2/2.
3) If necessary, press [
] to switch from
north latitude to south latitude or vice
versa. Key in latitude.
4) If necessary, press [
] to switch from
east longitude to west longitude or vice
versa. Key in longitude.
5) Press the [NU/CU ENT] key.
6) Press the [MENU ESC] key.
8.2 Units of Measurement
Unit of distance
Distance can be displayed in nautical mile,
kilometer or statute mile as follows.
1) Press [MENU ESC], [9] and [2]. The
UNIT SETUP menu appears.
Unit of Depth
Unit of Temp.
Unit of Altitude
UNIT SETUP
MENU : Escape
:Select
° C
° F
km sm
m
ft FA
m
ft
ENT : Enter
Unit of Distance
nm
Figure 8-3 UNIT SETUP menu
2) Press
to select Unit of Distance.
3) Press
or to select unit; nm, km or
sm.
4) Press the [NU/CU ENT] key.
5) Press the [MENU ESC] key.
Unit of depth
1) Press [MENU ESC], [9] and [2].
2) Press
or to select Unit of Depth.
3) Press
or to select unit; meter, feet,
or fathom.
4) Press the [NU/CU ENT] key.
5) Press the [MENU ESC] key.
Unit of water temperature
1) Press [MENU ESC], [9] and [2].
2) Press
or to select Unit of Temp.
3) Press
or to select unit; Centigrade
or Fahrenheit.
4) Press [NU/CU ENT] and [MENU ESC].
Unit of altitude
Available only in 3D mode.
1) Press [MENU ESC], [9] and [2].
2) Press
or to select Unit of Altitude.
3) Press
or to select unit.
4) Press the [NU/CU ENT] key.
5) Press the [MENU ESC] key.