Filter
Top Products
6. DATA TRANSFER
6-8
6.3 Loading Waypoint Data from Yeoman
Waypoint data can be loaded from a Yeoman to this equipment. Connect the
Yeoman to any DATA port on this equipment and then follow the procedure
below.
1. Press the [MENU] key.
2. Press the SYSTEM CONFIGURATION key.
3. Press the DATA TRANSFER soft key.
4. Press the RECEIVE YEOMAN DATA soft key.
5. You are asked if you are sure to receive waypoint data from Yeoman
equipment. Push the [ENTER] knob to receive the data.
The message “NOW RECEIVING YEOMAN DATA. PUSH SOFT KEY
‘STOP’ TO STOP RECEIVING.” Is displayed. If waypoint capacity is reached
the message “WAYPOINTS FULL. NO MORE WAYPOINT CAN BE
RECEIVED. PUSH ANY KEY TO STOP.” appears.
6. To stop receiving, press the STOP soft key.
7. After waypoints have been received, press the [MENU] key to close the
menu.