Filter
Top Products
5-1
5. CUSTOMIZING YOUR UNIT
This chapter describes the various options which allow you to set up your unit to
suit your needs. For mode-specific menus, e.g. radar, plotter and sounder, make
sure that you select the appropriate display when making changes or viewing
menu options.
5.1 General Setup
This paragraph shows you how to set up functions common to the plotter, radar
and sounder displays. This is done on the GENERAL SETUP menu, which you
may display from any mode. These items include language, key beep, units of
measurement, data sources, etc.
1. Press the [MENU] key to display the main menu.
2. Press the SYSTEM CONFIGURATION soft key.
3. Press the GENERAL SETUP soft key.
GENERAL
SETUP1
RETURN
NEXT
PAGE
EDIT
KEY BEEP
ON
LANGUAGE
ENGLISH
RANGE UNIT
nm, kt
TEMPERATURE UNIT
°F
DEPTH UNIT
ft
TEMPERATURE SOURCE
NMEA
DEPTH SOURCE
NMEA
RESET TRIP LOG
NO
SPEED SOURCE
NMEA
Page 1 (GD-1700C/1710C, GD-1700)
PREV.
PAGE
GENERAL
SETUP2
EDIT
LAT/LON DISPLAY
DD° MM.MMMM'
TD DISPLAY
LORAN C
SPEED
SOG
POSITION DISPLAY
LAT/LON
TIME DISPLAY
24 HOURS
INFRARED REMOTE MODE
A
RANGE & BEARING MODE
RHUMB LINE
BEARING READOUT
MAGNETIC
MAGNETIC VARIATION
AUTO 07.0° E
Page 2 (GD-1700C/1710C)
PREV.
PAGE
GENERAL
SETUP2
EDIT
LAT/LON DISPLAY
DD° MM.MMMM'
TD DISPLAY
LORAN C
SPEED
SOG
POSITION DISPLAY
LAT/LON
TIME DISPLAY
24 HOURS
INFRARED REMOTE MODE
A
RANGE & BEARING MODE
RHUMB LINE
BEARING READOUT
MAGNETIC
MAGNETIC VARIATION
AUTO 07.0° E
DISPLAY MODE
DAY
Page 2 (GD-1700)
General setup menu
4. Press the NEXT PAGE or PREV. PAGE soft key to switch pages if
necessary.
5. Use the cursor pad to select item.
6. Press the EDIT soft key.
7. Use the cursor pad to select option desired, then press the ENTER soft key
or [ENTER] knob.
8. Press the [MENU] key to close the menu.