Filter
Top Products
1. OPERATIONAL OVERVIEW
1-6
1.2 Inserting a Chart Card
Your unit reads FURUNO and NavCharts™ (NAVIONICS) chart cards, or
C-MAP chart cards, depending on the type of display unit you have. Insert the
appropriate chart card for your area as follows:
1. Open the chart card slot lid.
Chart slot
Card drive
Display unit Memory card interface unit
(option)
2. Insert desired chart card groove side up.
3. Close the lid to protect the chart drive.
Note 1: Do not remove a card while the chart is being drawn. This may cause
the equipment to freeze.
Note 2: Do not insert or remove a card while the power is on. This may cause
the equipment to freeze.
Note 3: For multiple display units, do not use the same chart card type in more
than one display unit.
Note 4: A card remover is supplied to ease removal of chart cards. Attach the
card remover to the right-hand side hole on the card and pull to remove
card. You can leave the card remover attached to the card while the
card is in the card slot - push the card remover leftward until it contacts
the recessed area in the card.
Chart card and card remover