Filter
Top Products
1. RADAR OPERATION
1-5
1.4 Main Menu
You may access the MAIN menu from the full keyboard or by using the trackball.
In later sections only the procedure for menu operation by trackball is given.
Main menu operation by keyboard
1. Press the [MENU] key. The MAIN menu appears in the text area at the right
side of the screen.
[MAIN MENU]
1 [ECHO]
2 [MARK]
3 [ALARM]
4 [ARP
l
AIS]
5 [PLOTTER]
6 [CARD]
7 [NAV DATA]
8 [NAV LINE
z
WPT]
9 [CUSTOMIZE
z
TEST]
Echo processing functions
Mainly turns markers on/off.
Sets guard alarm functions; outputs alarm signal.
Sets ARP
and AIS functions.
Chart and track functions
Memory card functions
Turns nav data on/off.
Processes nav lines and waypoints.
Customizes operation; executes diagnostics.
MAIN menu
2. Press the numeral key corresponding to the menu you wish to open. For
example, press the [2] key to open MARK menu.
[MARK]
1 BACK
2 OWN SHIP MARK
OFF/ON
3 STERN MARK
OFF/ON
4 INDEX LINE BEARING*
1
REL/TRUE
5 INDEX LINE*
2
1/2/3/6
6 INDEX LINE MODE*
3
VERTICAL/HORIZONTAL
7 [BARGE MARK]
8 EBL OFFSET BASE
STAB GND/STAB HDG/
STAB NORTH
9 [EBL, VRM, CURSOR SET]*
4
0 RING
OFF/ON
*
1
W-type shows INDEX LINE1. Same choices as INDEX LINE.
*
2
W-type shows INDEX LINE2. Same choices as INDEX LINE.
*
3
Shown when INDEX LINE is set to other than "1" .
Not shown on IMO or A type.
*
4
IMO and A types show
9 EBL CURSOR BEARING (REL/TRUE)
MARK menu
3. Press the numeral key corresponding to the
item you wish to set.
4. Consecutively press the same numeral key
pressed at step 3 to choose appropriate
option and then press the [ENTER MARK]
key to register your selection.
5. Press the [MENU] key to close the menu.
z
To clear a line of numeric data:
Use the [CANCEL TRAILS] key.
z
Switch between plus and minus,
North and South or East and West:
Use the [2] key.
Useful keys in menu operation