Filter
Top Products
5. VIDEO PLOTTER OPERATION
5-9
4. Roll the wheel to choose ON and then push the wheel or the left button.
“ALIGN” appears (in red) next to cursor position in the text area. (To remove
the correction, choose OFF. If you are using the AIS function, choose ON.)
5. Push the right button twice to close the menu.
5.7 Chart Cards (B, C and W types)
FURUNO or NAVIONICS charts may be overlaid on the radar image of the B, C
and W type radars when they are interfaced with the optional Card I/F Unit
CU-200.
CAUTION
Handle chart cards and memory cards
with care.
Keep cards away from direct sunlight,
heat sources, and active gases.
Keep cards away from water and
chemicals.
Keep the connector free foreign
material.
Do not drop the cards.
Chart cards are intended as an aid to
navigation. The navigator has the
responsibility to check all aids available
to confirm position.
5.7.1 Displaying a chart
To display a chart:
1. Insert a chart card in either of the two card slots in the Card I/F Unit CU-200.
Card Slot
+
+
1
2
Card slot location
2. Press the [POWER] button on the control unit to turn the power on. With the
radar in transmit status, choose the radar display (NU, CU, TM modes only)
or the radar/video plotter display to display the chart.
To display a chart after the power has been turned on, change the range by
pressing the [RANGE+] or [RANGE-] key or operating the RANGE box.