Filter
Top Products
5. VIDEO PLOTTER OPERATION
5-22
[WPT SET]
1 BACK
2 WPT NO. SELECT
000
3 WPT NAME
4 WPT L/L
00°00.000 N
000°00.000 E
5 CLEAR DATA
3. Roll the wheel to choose 6 [WPT SET] and then push the wheel or the left
button.
WPT SET menu
4. Roll the wheel to choose 2 WPT NO. SELECT and then push the wheel or
the left button.
5. Use the wheel to choose waypoint number: Roll the wheel to choose location
and then push the wheel to set.
6. To enter waypoint name, follow the procedure below. If you do not require
waypoint name go to step 7.
a) a) Roll the wheel to choose 3 WPT NAME and then push the wheel or the
left button.
b) b) Roll the wheel to choose alphanumeric character desired and then push
the wheel.
c) c) Repeat step 2 to complete the waypoint name. You may use up to 15
alphanumeric characters for waypoint name.
7. Roll the wheel to choose 4 WPT L/L and then push the wheel or the left
button.
8. Enter latitude and longitude position as follows:
d) a) Roll the wheel to choose location desired and then push the wheel. (The
wheel may be pushed again to skip a place.) For input by keyboard, press
appropriate numeric keys and then press the [ENTER MARK] key.
e) b) To switch co-ordinate polarity, roll the wheel or use the [2] key in case of
keyboard operation.
9. To enter another waypoint, repeat steps 4-8.
10. Push the right button three times to close the menu.