Filter
Top Products
rag between the handle and the door trim
panel at its lower gap (photo).
5 Insert the fingers or a broad blade between
the trim panel and the door and release the
panel.
6 Remove the trim panel and the waterproof
sheet (photo).
7 Refitting is a reversal of removal, but when
refitting the window regulator handle locate its
retaining spring clip fully and then simply
locate the handle on its splined shaft and
strike it sharply with the hand. Make sure that
with the window fully closed, the angle of the
regulator handle matches the one on the
opposite door (photo).
12 Door - dismantling
3
1 Remove the trim panel as described in the
preceding Section.
Lock remote control handle
2 Slide the handle rearwards to disengage
the tabs from the cut-outs.
3 Rotate the lock handle and disconnect it
from the link rod.
Door glass
4 Extract the screws from the glass
mounting.
5 With the glass fully lowered, remove the
weatherseal strips from the glass slot in the
door.
Fig. 12.9 Door window regulator fixing
screws (Sec 12)
Fig. 12.8 Removing door glass (Sec 12)
Fig. 12.7 Removing door weatherseal
(Sec 12)
Fig. 12.6 Door glass mounting screw
(Sec 12)
12•6 Bodywork
11.7 Window regulator handle ready for
fitting
11.6 Removing door trim panel11.4 Window regulator handle removed
11.3B Remote control handle withdrawn11.3A Removing remote control handle
escutcheon
11.2 Door tidy bin screw