Filter
Top Products
2.7 Gate Tracker
This gate operator is equipped with outputs from the circuit board that will report operator status to a
companion DoorKing Access Control System (Model 1833, 1835, 1837 or 1838) when equipped with
an optional Tracker expansion board. This report includes items such as gate operator cycle count,
any shorted inputs, loop detector problems, any attempts to force the gate open, if the gate has struck
anything during the open or close cycle, power interruptions, etc.
Gate Tracker™ connections are made at terminals 1, 3, 4, 9 and 10 on the main terminal strip. For
more detailed information on Gate Tracker™ and wiring to the Tracker expansion boards, refer to the
Tracker Installation and Wiring Manual, DoorKing P/N 2351-010.
Maximum wire run for gate operator data to the tracker board is 500 feet using Belden #9931
shielded cable or Consolidated #5324-CL shielded cable. Float the shield at the tracker board. Do
not connect the shield to the tracker board common.
Wire connection from the tracker board terminal P1-5 to the 4403 main terminal 4 is optional if the
gate operator
is not to be activated by the tracker output relay.
24V COMMON 1
PARTIAL OPEN 5
24V RADIO PWR 3
OPEN / RADIO RELAY 2
OPEN 4
3-BUTTON OPEN 7
3-BUTTON CLOSE 8
REVERSE / STOP 6
TRACKER DATA 9
TRACKER BUSY 10
1 Gate 1 Data IN
2 Gate 1 BUSY
3 Gate 2 Data IN
4 Gate 2 BUSY
5 Gate 1, 2 Data COMMON
6
7
8
9
10
11
12 Gate 1 Power Monitor
13 Gate 2 Power Monitor
14
15
16
17
18
P2
2351-010
Tracker Board
2
1
2
Belden 9931 or Equivalent.
1
Connect to Tracker board terminal P1-5. Required only if Tracker board activates
gate operator. Refer to manual 2351-065 for additional information.
3
3
Terminals 1 and 13 on the 4403 board are electrically identical. Either may be used
to connect to Tracker board terminal P2-5.
4
4
4
If Gate 1 terminals are in use on the Tracker board, use Gate 2 terminals.
DOORKING, INC., INGLEWOOD, CA 90301
Title:
Date: Rev.Dwg. No.
Gate Tracker to 4403 Board
A
9/03 M9310-065-5
27