DKS Enterprises 9310 Automobile Parts User Manual


 
1.3 Operator Installation
Position the operator on the pad so that
there is a minimum clearance of one (1)
inch between the back of the operator
housing and the gate.
90°
IMPORTANT!! Be sure that the operator
is parallel to the gate! Installing the
operator in any other manner will cause
excessive chain noise, chain wear and
stretching, and premature idler failure.
Mark the mounting holes on the mounting
pad. Use a concrete drill bit to drill the
mounting holes to the size and depth
required for the anchors being used. We
recommend 1/2 x 2 or 3/8 x 2 sleeve
anchors (not supplied).
NO!
After drilling the mounting holes, clean
them out and install the sleeve anchors.
Position the operator over the anchors
and tighten.
15