DKS Enterprises 9310 Automobile Parts User Manual


 
2.6 Loop Detectors
Loops and loop detectors must be installed with this gate operator to prevent the gate from
accidentally closing on vehicles that may be in the path of the gate.
Loop detector wiring is shown for DoorKing model 9406 Plug-In loop detector only. If other
loop detectors are used, refer to the installation instructions supplied with those detectors for
wiring requirements.
If other loop detectors are used, all inputs to the terminal strip are NORMALLY OPEN. Use a
separate power supply to power external detectors. Be sure that power is turned off prior to
making any connections to the terminal strip.
Loop layout shown is for a typical slide gate application with two-way traffic or one-way exit
only traffic. For one-way entry only traffic, the exit loop and loop detector are not needed.
Refer to the separate Loop Information Manual (available from DoorKing) for instructions on
installing loops or preformed loops.
Reverse loops are wired in series (detail A)!
DOORKING, INC., INGLEWOOD, CA 90301
Title:
Date: Rev.Dwg. No.
Loop and Loop Detector Wiring
9310 Operator
A
9/03 M9310-065-4
1
Exit
Reverse
REVERSE LOOP
EXIT LOOP
REVERSE LOOP
TB 1
Loop Detector
P/N 9406-010
TB 1
Loop Detector
P/N 9406-010
Reverse loops are wired in series!
1
26