Filter
Top Products
QSTD5304 Digital Video Recorder User Manual
17
3.2.4 Alarm Configuration
Alarm Setup menu is shown as Fig. 3.9.
MOTION ALARM
If you select Motion Alarm in Alarm Configuration the submenu shown as Fig.
3.10 will be displayed.
1. HOLD TIME
This sets the continued recording time after an alarm is triggered. There are
two options: 1 minute and 2 minutes. It also determines the interval between
motion detection events. If the HOLD TIME is 1 minute, if new motion is
detected within this period it will be considered part of the previous event
instead of the start of a new event.
2. CHANNEL
STEP1 Move the cursor to the channel.
STEP2 Press "Enter" key to switch the channel and select.
3. DETECTION
Checking "DETECTION" means to enable motion detection, not checking
means motion detection will not be enabled.
4. SENSITIVITY
This is the sensitivity level of the motion sensors.
The range is from ‘1’ to ‘8’. The higher the value, the more sensitive.
Fig 3.9 Alarm Configuration
Fig 3.10 Motion Alarm Configuration