Filter
Top Products
28
1. Press and hold the button for 3 second. The alarm will immediately sound.
2. During panic mode, the normal function of this transmitter button will be suspended. The transmitter and buttons can
be used to lock and unlock the door (if the option is installed), however once the button is pressed, the vehicle’s starter
disable device, (where installed) will be enable allowing the vehicle to start. To stop the alarm, press and hold the
transmitter button on the transmitter again for 3 seconds. Also button is pressed and released, the panic mode will
be turned off immediately.
3. If the button is not pressed, the alarm will automatically stop after 30 seconds.
TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impact will trigger the warn-away signal.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turn on the ignition key will trigger the programmed sequence.
DOME LIGHT CONVENIENCE DELAY & SUPERVISION
The alarm with a unique feature which will turn on your vehicle dome light as following:
1. Upon disarming, the interior light will remain on for 30 seconds.
2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turn on the ignition switch or arm the alarm will turn off the dome light.
IGNITION CONTROL DOOR LOCK/UNLOCK (OPTIONAL)
If the vehicle’s door locks have been interfaced to the security system, the system will automatically lock the vehicle's doors
when the ignition is turned “ON” and /or unlock the vehicle’s doors when the ignition is turned “OFF”.
RANGE CHECK (OPTIONAL)
If this feature is selected, the system will automatically check the range every 20 minutes after armed.
1. If user is within the range, the LED will slowly pause flashing.
2. If user is out of range, the LED will turns off.
Note: Programming “Out Of Range Indication” will decrease the life expectancy of battery.
THE ACTION OF THE 2-WAY LED REMOTE CONTROL TRANSCEIVER
Within the range LED will slowly pause flashing
Out of the range LED turns off.
POWER ON MEMORY: This security system is equipped with circuitry that will allow the unit to remember its alarm state if
the power is lost and then reconnected.