Filter
Top Products
26
TAMPER DISARMING
If alarm triggered, upon disarm the system, siren chirp 4 times, parking light flash 3 times.
TWO STEPS DOOR UNLOCK (OPTIONAL)
This feature will independently unlock the driver’s door only when disarming the security system. Pushing the button a
second time within 2 seconds will unlock the other doors.
DISARMING WITHOUT A TRANSMITTER
OVERRIDE THE ALARM WITHOUT PASSWORD PIN CODE (Factory Default Setting)
The Override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm will sound.)
2. Within 10 seconds push and release the valet switch
The alarm will stop sounding and enter the disarm mode. You can now start and operate the vehicle normally.
PASSWORD PIN CODE SETUP Note: Pin code only 2 digits and can’t be set to #0.
Goes to option #9 “Override pin code”. Press button #1 to turn “ON” override pin code.
1. Within 15 seconds, begin to enter the first digit of your chosen pin code by pressing and releasing the program/valet
button from 1-9 times, the horn and siren will chirp on each press.
2. Turn ignition OFF, then turn back “ON”.
3. Within 15 seconds, begin to enter the second digit of your chosen pin code by pressing and releasing the
program/valet button from 1-9 times, the horn and siren will chirp on each press.
4. Turn ignition “OFF”. If the new password pin code was accepted. The unit would report back the newly enter code by
flashing the status LED. First indication the first digit code has been memorized, pause and then the indication the
second digit code, unit will repeat the new password pin code 3 time to confirm. Then unit automatically exit by it self.
OVERRIDE THE ALARM WITH PASSWORD PIN CODE
Unlike valet button easily found, and defeated, this security system allows the consumer to program a password pin code.
Offering a higher level of security.
1. Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm will sound.)
2. Within 5 seconds, enter your chosen the first digit code by press and release the Program/Valet button.
3. Within 15 seconds enter (the 1st code); turn the Ignition Switch “OFF” and then “ON”.
4. Within 15 seconds, enter your chosen of the second digit code by press and release the Program/Valet button. (Alarm
will stop)
5. Turn the ignition switch “OFF” position. [4] Chirps form siren/horn, [3] flash from parking light to indicate the system was
disarmed.