Crimestopper Security Products CS-2205 Automobile Alarm User Manual


 
25
particular zone will NOT be protected by the alarm. All remaining functioning zones will still be protected if the system
remains armed.
AUTOLOCK/UNLOCK
Autolock / Unlock allow the alarm to control the door locks automatically with the vehicle’s Ignition. When the ignition is
turned on, 3 seconds later, the doors will lock. When the ignition is turned off, the doors will unlock. Door lock with Ignition
ON will not occur if a door is open to prevent accidentally locking the keys in the vehicle.
ACTIVE RE-ARMING (FAIL-SAFE PROTECTION)
Active Re-arming means that the system will re-arm itself 60 seconds after disarmed with the transmitter [if a door has not yet
been opened]. This is handy if the vehicle is accidentally disarmed (via the transmitter in your pocket) without your
knowledge. The Active rearm feature is disabled if you have dome light illumination installed.
SHOCK SENSOR BY-PASS
Press the button on the transmitter two times within 3 seconds will arm the security system and by-pass the shock sensor.
The system will chirp one additional time to confirm the sensor bypass mode was activated. The sensor bypass feature is
programmed to activate for one arming cycle only. The security system will return to normal operation during the next arming
cycle.
HIDDEN ALARM FUNCTION
Press the button first; within 3 seconds press the ( ) button to activate the hidden alarm function. The security system
will arm and with “Hidden Alarm Function”. The siren / horn will be silenced even if the alarm is triggered in the armed status.
PASSIVE ARMING (OPTIONAL)
Active arming / disarming is controlling your security system via the remote transmitter. This security system is equipped
with an optional Passive Arming feature, which allows the security system to arm 30 seconds after the last door is closed.
Operation is as follows.
1. Turn the ignition to the “OFF” position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast for 30 seconds. If you reopen any door / hood /
trunk, the security system LED will stop flashing. It will begin flashing again once all vehicle entrances are closed.
3. After 30-second timer has elapsed, the security system will automatically “ARM”. The siren will chirp [1] time and the
parking lights will flash [1] time.
PASSIVE ARMING BY-PASS
While the system disarmed, Press the button twice, the security will respond with [1] chirp and LED will turn ON”. The
security system will remain in this temporally state for as long as you wish. To exit passive by-pass, press the transmitter
or button and the system will return to normal status.