Crimestopper Security Products CS-2205 Automobile Alarm User Manual


 
24
OPERATION
ARMING
To arm the alarm and lock the doors, press the #1 Button on any remote. You will hear a single siren chirp and the lights will
flash once. The system will arm, the doors will lock (optional) and the starter (optional) will be disabled. The red in-dash LED
in the vehicle will begin to flash. After a short delay of 10-15 seconds to allow vehicle and electronics to stabilize the system
will be completely armed.
DISARMING
To disarm the alarm and unlock the doors, press the #2 Button on any remote. You will hear 2 siren chirps and the lights will
flash twice. The in-dash LED stops flashing dome light turns on (Optional). If the alarm is currently tripped, then the #2
Button will have to be pressed two times. The first press will only reset the pager (Beep) and the second press will disarm
the system.
ALARM TRIGGERING
If there is an intrusion into the vehicle, the alarm siren will sound and flash the lights for 30 sec.. This is known as a cycle.
After the cycle, the system will automatically reset and continue to protect the vehicle. If a door was left opened, then the unit
will trigger up to 6 cycle, reset, and continue to protect the other un-tampered zones.
REMOTE PANIC PROTECTION
To sound the alarm upon command (panic), press and hold the Button #4 on any transmitter for at least 2 seconds until the
siren sounds and lights flash. Repeat again to reset the panic mode. Panic will sound for a maximum of 30 sec.
SILENT ARM/DISARM
Press the transmitter and buttons at the same time will arm or disarm your security system, No chirp sound will be heard,
arm / disarm confirmation will be through the vehicles parking lights only.
SHOCK / IMPACT PROTECTION WITH PRE-WARNING
Once the system is armed, if a low-level shock to the vehicle body is detected, the pre-warning sensor activates LED Remote
and parking light flash three 3 times as a Warn-Away feature. If a hard impact to the vehicle is detected the system will go
into a full trigger cycle for 30 seconds. Adjust the shock sensor as needed by turning the control knob clockwise or counter-
clockwise to increase or decrease the sensitivity. Shock sensors will “settle in” over time and it may take a few tries over a
few weeks. To get the adjustment correctly for your vehicle, we recommend a moderate adjustment where the vehicle is
protected but it is not constantly triggering from the slightest vibration creating a nuisance.
DOOR OPEN WARNING
If the system detects a faulty or open zone (Door left open), it will notify you by providing 3 warning chirps from the siren 5/60
seconds after arming. If you receive this warning, check to see if a door is ajar. If you are unable to do so, then this