Filter
Top Products
14
PROGRAMMABLE OPTIONS
You can program multiple options in one session if you start with the lowest option and continue on to higher options [if needed]
without repeating steps #1-3 below. For example, you can follow the programming steps to change Option #2 to “OFF” by pressing
the lock button on the remote, then you can continue pressing the program button additional times to get to a high number option
and change the setting without having to repeat Steps 1-5. You can only go from low to higher option numbers in one session.
To Engage Option Programming:
1. Turn Key to the ON position
2. Press program / valet button 5 times, after a few seconds the unit will flash the lights 5 times.
3. Push the valet/program button [again] the number of times that corresponds to the option number desired (1 thru 25).
You must get a light flash after each button press. See chart on next page for option list.
4. When you reach the desired programming level, Press button #1, #3 or #4 to change the option.
5. Turn Ignition OFF and check for changed features. Change each option individually repeating #1-4.
AUX Channel 1 (2 / 3 / 4) Timed Output Programming
1. After you reach the desired Aux Channel programming option, press transmitter button #4 ( symbol). The LED, Siren
and Horn flash 4 times to indicate you are in Timer Programming mode”.
2. Press and hold the valet switch, the timer will immediately start.
3. When the desired interval has passed, release the valet switch. You will get one long chirp for confirmation. (Set to any
interval between 1 second and 2 minutes)
Note 1: If your built-in timer controls window/sunroof closure in your car DO NOT change the timer setting! This
requires installer-only programming. Changing the value will adversely effect operation and may cause
damage.
Note 2:
Momentary output = The momentary output selection will output a negative signal from the Channel 2, 3 or 4 output
immediately when the channel 2, 3 or 4 button is pressed and will continue until the button is release.
Latched output = The latched output selection will output a negative signal as soon as the Channel 1/2/3/4 button is
pressed and will continue until the button is pressed again.
Latched output / reset with ignition = The latched / reset with ignition output selection operates just like the latched
output but will reset or stop when the ignition is turned on.