Filter
Top Products
15
Turning
. . . . . . . . . . .
the system
on and off
Turn the system on
. . . .
When connected to a p o w e r s o u rce, the system needs to be turned on to operate and can remain
on for as long as it is in use. After a period of inactivity, the system will either enter sleep mode
(see below) or turn itself off using SmartPower (see page 21) to avoid draining the vehicle battery.
When the system is off:
1. Press and hold the POWER button on the left side of the unit until the function buttons
are illuminated.
The system will turn on and the
Cobra screen A will appear on the LCD. The
Cobra screen
will be visible briefly, then change to the
PLEASE DRIVE SAFELY screen B. This safety
reminder appears following each start-up and must be acknowledged before proceeding.
When the system is on:
1. Press the POWER button on the left side of the unit.
The system will retain information to be recalled when it is turned on again.
The
Display Saver screen C conserves power and the life of the LCD whenever the system is in sleep
mode. Sleep mode is activated automatically if the user takes no action at the
PLEASE DRIVE SAFELY
screen B for ten seconds after it appears. This occurs only at the
PLEASE DRIVE SAFELY screen B
and is different from a SmartPower shutdown. (See page 21 for information on SmartPower.)
Turn the system off
. . . .
NOTE
If the unit is plugged
into a socket controlled
by the ignition switch,
turning off the ignition
will also turn off the
system. When restarting,
the POWER button needs
to be pressed to turn
the system on again.
NOTE
Sleep mode functions
when SmartPower is
turned on or off.
Display saver
. . . . .
and sleep mode
02 B Startup 6/15/04 5:28 PM Page 15