Filter
Top Products
P a rt II — Getting Start e d
Nothing comes close to a Cobra
®
11
B. The gyro in the NAV ONE 3000 will operate properly only if the unit is
in a near-vertical position. This means that the unit should not be tilted
front-to-back or side-to-side. With the unit in the vertical position,
it can be rotated in the horizontal plane to any convenient viewing angle.
To secure and connect the NAV ONE:
1. Select a suitable location where the unit can be mounted vertically
and clean the mounting area.
2. Separate the suction cup and mounting bracket assembly from the unit.
3. FIRMLY press the suction cup against the windshield by applying pressure
to the central PRESS button. Be sure the button is pressed all the way in
to make sure ALL the air is out of the suction cup.
4. While maintaining FIRM pressure on the button, pull the lock lever up or
down over the button.
5. Test suction cup adhesion by pulling on the bracket. THE ASSEMBLY
SHOULD NOT WIGGLE. If it does, unlock the lever and repeat steps 3 and 4.
6. Attach the unit to the mounting bracket by means of the quick release feature.
7. Plug the power cord into the unit and the vehicle’s 12 volt power socket.
The unit should be as close
to vertical as possible and
not tilted front-to-back or
side-to-side.
View From the Top
WARNING
If the unit is not securely
attached to the vehicle, it
can become a projectile
hazard to the vehicle’s
occupants during a violent
maneuver or a collision.
The unit can cause serious
i n j u ry under the influence
of forces resulting from such
accelerations or decelerations.
Secure and
. . . . . . . . . . .
connect the
NAV ONE
A t t a c h the mounting bracket to the windshield.
A t t a c h the unit to the mounting brack e t .
WA R N I N G
All air must
be removed.
01 Intro 6/15/04 5:26 PM Page 11