Cisco Systems X350 GPS Receiver User Manual


 
QUICK START GUIDE
7 Binatone Help Line: 0845 345 9677 (for UK only. Local Call rate)
Turning the Sat Nav Unit On/Off
To switch the unit On slide the power switch located on the back of the unit to the On
position, the unit will power up and display the warning screen.
To switch the unit Off slide the power switch to the Off position.
Turning the Sat Nav Unit Off Via Sleep Mode
Press and hold down the sleep button on the top of the unit, after about 3 seconds
the unit will enter sleep mode. Press and hold the button again, to bring the unit out
of sleep mode. When brought out of sleep mode the unit will show the same screen
as when the unit entered sleep mode.
If the unit is not to be used for a long period of time it is advised that you slide the
power switch on the back of the unit to Off.
System Reset
Under extreme circumstances it may be necessary to reboot the system. Reset the
system if the following situation occurs:
Long delay experienced with screen refresh rate or operation, resulting in an
inoperable unit.
The system will not turn Off with the power button.
No response with selection made on the screen.
The reset button can be found on the back of the unit. Insert the tip of the stylus pen
into the reset switch in order to press. The system will be immediately reset.