Filter
Top Products
To program features, your vehicle must be in the
programming mode. Follow these steps:
1.
2.
3.
4.
5,
Put your key in the ignition.
Turn the ignition to the
RUN
position to disarm the
Vehicle and Content Theft-DeterrentlAlarm System.
Turn the ignition to the
OFF
position.
Remove
the
RADIO fuse. This
fuse
is in the main
fuse block, located on the left side
of
your
instrument panel. When the main fuse block is open,
the RADIO fuse is located in the lower right hand
corner of the fuse panel. See “Fuses and Circuit
Breakers’’ in the Index.
Turn the ignition
to
the ACC position.
You should hear a chime to verify that the system is
in programming mode, If the chime sounds once,
you will be able to program Exit Lighting, Delayed
Illumination, Last
Door
Closed Locking and Lockout
Prevention only. If the chime sounds twice and your
vehicle is equipped with the Vehicle and Content
Theft-Deterrent System,
you
will also be able to set
Remote Keyless Entry Verification, Arming Method,
Arming Verification, Driver’s Door Delay and Shock
Sensor Enable.
Exit Lighting and Delayed Illumination
Exit Lighting: Your interior lights will come on for up
to
25
seconds when the key
is
removed from the
ignition switch.
Delayed Illumination: Your interior lights will come
on
and stay on for up to
25
seconds when entering the vehicle
and for up
to
five seconds when leaving your vehicle.
Your
vehicle comes with
both
features enabled. (Mode
4)
To
change the factory setting, do the following:
1. Turn the courtesy la~nps on by turning the instrument
panel brightness control knob all the way up.
2.
Count the number of chimes you hear. The number
of
chimes tells you which mode your vehicle is
set
for.
3.
Turn the courtesy lamp switch to
OFF.
4.
Turn the courtesy lamp switch from
ON
to
OFF
until
you
hear
the
number
of
chimes that correspond to the
mode selection you want.
Mode
1:
Both
Off
Mode
2:
Delayed Illumination Only
Mode
3:
Exit Lighting Only
Mode
4:
Both On
2-19