Filter
Top Products
Finding a Station
AM-FM:
Press this button to switch between AM, FMl
and FM2. The display shows your selection.
TUNE:
Press this knob lightly
so
it extends. Turn it to
choose radio stations. Push the knob back into its stored
position when you’re not using it.
SEEK:
Press the right or left arrow to go to the
next higher or lower station. The sound will mute
while seeking.
SCAN:
Press and hold
SEEK
for
two seconds until
SCAN appears on the display. SCAN allows you to
listen to each station for a few seconds. The radio will
go to
a
station, stop for a few seconds, then go on
to
the
next station. Press
SEEK
again
to
stop scanning. The
sound will mute while scanning.
PUSHBUTTONS:
The six numbered pushbuttons let
you return to your favorite stations. You can set up to
18
stations (six AM, six FM 1 and six FM2). Just:
1. Press AM-FM to select the band.
2.
Tune in the desired station.
3.
Press AUTO TONE
to
select the equalization that
best suits the type
of
station selected.
4.
5.
Press and hold one
of
the six numbered buttons. The
sound will mute. When it returns, release the button.
Whenever you press that numbered button, the
station
you
set will return and the AUTO TONE
equalization that you selected will also be
automatically selected for that button.
Repeat the steps for each pushbutton.
P.SCAN:
Press this button to listen to each
of
your
favorite stations stored on your pushbuttons for a few
seconds. The radio will scan through each of the stations
stored
on
your pushbuttons, except those stations with
weak reception. The AUTO TONE setting stored for
that pushbutton will be automatically chosen. Press
P.SCAN or
one
of the pushbuttons again to stop
scanning. P.SCAN will be displayed whenever the tuner
is in the P.SCAN mode. The channel number (Pl-P6)
will appear momentarily just before the frequency is
displayed. In FM mode, this function will scan through
both FM 1 and FM2 preset stations and FM 1 or FM2
will appear
on
the display.
3-10