Filter
Top Products
Adjusting the Speakers
BAL:
Turn the control behind the upper knob to move
the sound to the left or right speakers. The middle
position balances the sound between the speakers.
FADE:
Turn the control behind the lower knob to move
the sound to the front or rear speakers. The middle
position balances the sound between
the
speakers.
Playing
a
Cassette Tape
Your tape player is built
to
work best with tapes that are
30
to
45
minutes long on each side. Tapes longer than
that are
so
thin they may
not
work well in this player.
If
you
hear nothing or hear just a garbled sound,
it
may
not
be in squarely. Press EJECT to remove the tape and
start over.
While the tape is playing, use the
VOL,
FADE,
BAL,
BASS
and TREB controls just as
you
do for the radio.
Other controls may have different functions when a tape
is inserted. The display will show an arrow to show
which side
of
the tape
is
playing.
REV
Press the
SEEK
arrow
pointing to the left and the
tape will reverse rapidly until you press this button
again lightly.
FWD:
Press the
SEEK
arrow pointing
to
the right and
the tape will rapidly advance until you press this button
again lightly.
RECALL:
Press this knob
to
hear the other side
of
a
tape that is playing.
EJECT
Press this button to remove the tape. The radio
will play.
CLN:
If
this message appears
on
the display, the
cassette tape player needs to be cleaned. It will still play
tapes, but you should clean it as soon as possible to
prevent damage to the tapes and player. See “Care
of
Your Cassette Tape Player” in the Index. After you clean
the
player, press and hold EJECT for five seconds to
reset the
CLN
indicator.
The
radio will display
---
to
show the indicator was reset.
3-8