Filter
Top Products
Have each transmitter
you
intend to match ready
for
the
next steps.
To
match transmitters to your vehicle:
1.
2.
3.
4.
5.
6.
7.
Turn the ignition
to
the
RUN
position, then
to
the
OFF
position. This will disarm the Vehicle and
Content Theft-DeterrendAlarm System (if your
vehicle has this option).
Remove the RADIO fuse. This fuse is located in the
main fuse block, located on the left side
of
your main
instrument panel. See “Fuses and Circuit Breakers”
in the Index.
Turn the ignition switch from the
OFF
to the
RUN
position three times quickly (within five seconds).
The vehicle will respond by locking the doors,
unlocking the driver’s doors and releasing the hatch.
Your transmitter is now ready
to
match the vehicle.
Press and hold the LOCK and UNLOCK buttons
on
the first transmitter for
15
seconds. The vehicle will
respond as in step
3.
Repeat Step
4
for the remaining transmitters.
When you have finished matching all
of
your
transmitters, replace the
RADIO
fuse.
Check that all transmitters work by pressing
their buttons.
If
the transmitters don’t work, or if
you’d
rather not match
the transmitters yourself, see your Chevrolet dealer.
Battery
Replacement
Under normal
use,
the battery in your remote keyless
entry transmitter should last about two years.
You
can
tell
the battery is weak if the transmitter won’t
work at the normal range in any location. If
you
have to
get close
to
your vehicle before the transmitter works,
it’s probably time to change the battery.
Use one battery, type CR2032, or a similar type.
2-10