Filter
Top Products
DAILY LIVING
DDoocc NNoo::
21906503
RReevv::
02 Copyright © Hanmar Motor Corporation 2005
BB--44
SLEEPING FACILITIES:
REAR TWIN BEDS (190-Popular Model):
To convert the dinette into twin beds:
1. Remove the table and leg from its receptacle and
place the table under the driver side seat cushion,
(see Picture B-P6 on page B-3).
2. Place both back rest cushions on the floor
vertically up against the seat base boxes or store if
desired.
Warning: Do not allow cushions to block furnace vents.
3. Pull each seat cushion 3" (8 cm) from the wall to
provide additional elbow room while sleeping.
4. Night table can be removed and stored if desired,
(see Picture B-P9).
To convert back to a dinette, perform these steps in reverse order.
REAR KING-SIZE BED (190-Popular Model):
To convert the dinette into a king-size bed:
1. Remove the privacy curtain from its Velcro support
on the lower edge of the suspended cupboard door.
2. Remove the table and leg from its receptacle.
3. Remove night table and store. In order to remove,
unscrew the wing bolt found on each side of the
night table,(see Picture B-P9).Store wing nut in
the night tables drawer when not in use.
4. Place table top in center and wood insert as
shown, (see Picture B-P10).
5. Place both bolster cushions,(back rests) in centre
in a tepee position, (see Picture B-P11).
NOTE:The longer bolster cushion must be placed
on the driver side, so as to provide clearance for
the bathroom door.
6. Push down the bolster cushions so they lay flat to
create the king size bed.
To convert back to a dinette, perform these steps in
reverse order.
Picture B-P10: Placement of support pieces for the
king size bed, (Popular model).
Picture B-P11: Placement of back rest cushions,
(Popular model).
Picture B-P9: Wing nuts attaching the night table,
are accessed from the sides of the night table as
pictured above, (Popular model).