Filter
Top Products
9-42 Vehicle Care
A. Turn Signal Lamp
B. Back–Up Bulb/Socket
6. Disconnect the wire harness
from the back–up bulb/
socket (B).
7. Turn the back–up bulb socket
counterclockwise to remove it
from the taillamp assembly.
8. Press a new bulb/socket into the
taillamp assembly and turn the
bulb/socket clockwise until it
clicks.
9. Reinstall the taillamp assembly
and tighten the screws.
10. Reinstall the taillamp cover by
snapping it into place.
11. Push the push pin to secure
the taillamp cover.
License Plate Lamp
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
(Manual)
on page 1‑13
or
Liftgate (Power)
on page 1‑14
for more information.
Passenger side shown, driver side
similar
2. Push the left end of the lamp
assembly towards the right.
3. Turn the lamp assembly down to
remove from liftgate.