Filter
Top Products
Vehicle Care 9-37
2. Unlatch three clips and lift up the
underhood electrical center
cover to remove.
Passenger Side
The removal of the air filter/cleaner
assembly and base is required for
the replacement of one of these
bulbs:
1. Open the hood. See Hood
on
page 9‑5
.
A. Air Duct Clamp
B. Connector Lock
C. Sensor Connectors
D. Retaining Clips
2. Disconnect the outlet duct by
loosening the air duct clamp (A).
3. Remove the connector lock (B)
located at the bottom of the
sensor connector (C).
4. Press on the top and bottom of
the sensor connectors (C) and
remove.
5. Lift the three retaining clips (D)
on the air filter housing.
6. Turn and tilt cover slightly
upwards and slide cover away
from outside edge of vehicle.
Lift the cover away from base.
7. Lift the air cleaner/filter base to
disengage from three pins.