Filter
Top Products
8-34 Driving and Operating
TCS/StabiliTrak Light
When the stability control system
activates,
d flashes on the
instrument panel. This also occurs
when traction control is activated.
A noise may be heard or vibration
may be felt in the brake pedal. This
is normal. Continue to steer the
vehicle in the intended direction.
If there is a problem detected with
StabiliTrak, “Service StabiliTrak” is
displayed on the Driver Information
Center (DIC). See Ride Control
System Messages
on page 4‑38
.
When this message is displayed
and
d comes on and stays on,
the vehicle is safe to drive but the
system is not operational. Driving
should be adjusted accordingly.
If
d comes on and stays on, reset
the system by:
1. Stopping the vehicle.
2. Turning the engine off and
waiting 15 seconds.
3. Starting the engine.
If
d still comes on and stays on, the
vehicle needs service.
TCS/StabiliTrak Button
d is located on the console.
StabiliTrak Off
Light
TCS Off Light
StabiliTrak can be turned off
if needed by pressing and
holding
d until g and i come on
the instrument panel. When
StabiliTrak is turned off, the system
will not assist with directional control
of the vehicle or limit wheel spin.
Driving should be adjusted
accordingly. Press and
release
d again to turn the
system back on.
If cruise control is being used
when StabiliTrak activates, cruise
control will automatically disengage.
Press the cruise control button to
reengage when road conditions
allow. See Cruise Control
on
page 8‑35
for more information.