Filter
Top Products
Keys, Doors and Windows 1-7
4. Press the ignition. When the
transmitter is learned the DIC
display will show that it is ready
to program the next transmitter.
5. Remove the transmitter from
the transmitter pocket and
press
K on the transmitter.
To program additional
transmitters, repeat Steps 3
through 5.
When all additional transmitters
are programmed, press and hold
the ignition for 5 seconds to exit
programming mode.
Programming without a
Recognized Transmitter
(Keyless Access Vehicles Only)
If there are no currently recognized
transmitters available, follow
this procedure to program up to
eight transmitters. This feature
is not available in Canada. This
procedure will take approximately
30 minutes to complete. The
vehicle must be off and all of the
transmitters you wish to program
must be with you.
1. Insert the vehicle key of the
transmitter into the key lock
cylinder located on the outside
of the driver door and turn the
key to the unlock position
five times within ten seconds.
The Driver Information Center
(DIC) displays “Remote Learn
Pending, Please Wait”.
2. Wait for ten minutes until the
DIC displays “Press Engine Start
Button To Learn” and then press
the ignition.
The DIC displays will again
show “Remote Learn Pending,
Please Wait”.
3. Repeat Step 2 two additional
times. After the third time all
previously known transmitters
will no longer work with the
vehicle. Remaining transmitters
can be relearned during the next
steps.
The DIC display should now
show “Ready For Remote # 1”.