Filter
Top Products
9-34 Vehicle Care
6. Replace the blade with a
new one.
7. Reinstall the wiper blade
assembly by sliding it over the
wiper arm to engage the
J-hooked end. Pull up on the
assembly to lock it into place.
8. Repeat the steps for the other
wiper.
Headlamp Aiming
The vehicle has a visual optical
headlamp aiming system. The aim
has been preset at the factory and
should need no further adjustment.
However, if the vehicle is damaged
in a crash, the headlamp aim may
be affected and adjustment may be
necessary.
If oncoming vehicles flash their high
beams at you, this may also mean
the vertical aim needs to be
adjusted.
It is recommended that the vehicle
is taken to your dealer/retailer for
service if the headlamps need to be
re-aimed. It is possible however, to
re-aim the headlamps as described.
The vehicle should:
.
Be placed so the headlamps
are 7.6 m (25 ft) from a light
colored wall.
.
Have all four tires on a level
surface which is level all the way
to the wall.
.
Be placed so it is perpendicular
to the wall.
.
Not have any snow, ice, or mud
on it.
.
Be fully assembled and all other
work stopped while headlamp
aiming is being performed.
.
Normally loaded with a full
tank of fuel and one person or
75 kg (160 lbs) sitting on the
driver seat.
.
Have all tires properly inflated.
.
If your vehicle has a spare tire,
ensure the spare tire is in its
original location in the vehicle.
Headlamp aiming is done with the
vehicle's low-beam headlamps.
The high-beam headlamps will be
correctly aimed if the low-beam
headlamps are aimed properly.