Filter
Top Products
Keys, Doors and Windows 1-9
The vehicle comes with two
transmitters. Each transmitter will
have a number on top of it,
“1” or “2”. These numbers
correspond to the driver of the
vehicle. For example, the memory
seat position for driver 1 will be
recalled when using the transmitter
labeled “1”, if enabled through the
DIC. See “Memory Seat” under
Power Seat Adjustment
on
page 2‑4
and Vehicle
Personalization
on page 4‑51
for
more information.
Programming Transmitters
to the Vehicle
Only keyless access transmitters
programmed to the vehicle will work.
If a transmitter is lost or stolen, a
replacement can be purchased
and programmed through your
dealer/retailer. The vehicle can be
reprogrammed so that lost or
stolen transmitters no longer work.
Each vehicle can have up to
four transmitters matched to it.
Programming with a Recognized
Transmitter
A new transmitter can be
programmed to the vehicle when
there is one recognized transmitter.
For vehicles sold in Canada, two
recognized transmitters are required
to program a new transmitter.
1. The vehicle must be off.
2. Place the recognized
transmitter(s) in the cupholder.
Have the new transmitter
available with you.
3. Insert the vehicle key into the
key lock cylinder located on the
outside of the driver door.
4. Turn the key to the unlock
position five times within
five seconds.
5. The Driver Information Center
(DIC) displays Ready To Learn
Electronic Key #2, 3 or 4.
6. Place the new transmitter into
the transmitter pocket with the
buttons facing the front of the
vehicle. The transmitter pocket
is inside the center console
storage area located between
the driver and front passenger
seats.
7. A beep sounds once the
transmitter is programmed.
The DIC displays Ready To
Learn Electronic Key #3 or 4,
or Maximum # Electronic Keys
Learned.