Filter
Top Products
1-10 Keys, Doors and Windows
8. Press the ignition control knob to
exit programming mode.
9. Remove the transmitter from
the transmitter pocket and
press
K on the keyless access
transmitter two times.
10. To program additional
transmitters, repeat Steps 6
through 9.
Programming without a
Recognized Transmitter
United States owners are permitted
to program a new transmitter to
their vehicle when a recognized
transmitter is not available. The
Canadian immobilizer standard
requires that Canadian owners
see their dealer/retailer for
programming new transmitters
when two recognized transmitters
are not available.
The procedure requires three,
ten minute cycles to complete the
matching process.
1. The vehicle must be off.
2. Place the new transmitter into
the transmitter pocket with the
buttons facing the front of the
vehicle. The transmitter pocket
is inside the center console
storage area located between
the driver and front passenger
seats.
3. Insert the vehicle key into the
key lock cylinder located on the
driver door.
4. Turn the key to the unlock
position five times within
five seconds.
5. The DIC displays Press Start
Control To Learn Keys.
6. Press the ignition switch in.
7. The DIC reads Learn Delay
Active Wait XX Min and counts
down to zero.
8. The DIC displays Press Start
Control To Learn Keys again.
9. Press the ignition switch in
again.
10. Repeat Steps 7, 8 and 9.
11. The DIC reads Learn Delay
Active Wait XX Min and counts
down to zero.
12. A beep sounds and the
DIC reads Ready To Learn
Electronic Key # X. All
previously known transmitter
programming has been erased.