Filter
Top Products
Infotainment System 6-45
3. Say the name tag of the person
to call.
.
If the system clearly
recognizes the name tag it
responds with “OK, calling,
<name tag>” and dials the
number.
.
If the system is unsure it
recognizes the right name
tag, it confirms the name
tag followed by a tone.
If the name tag is correct,
say “Yes”. The system
responds with “OK, calling,
<name tag>” and dials the
number. If the name tag is
not correct, say “No”. The
system will ask for the
name tag to be re-entered.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re-dial Command
1. Press and hold
b g for
two seconds:
.
For vehicles without a
navigation system, the
system responds with
“Ready” followed by a tone.
.
For vehicles with a
navigation system, the
system responds with a
tone. After the tone say
“Hands Free”. The system
responds with “Ready”
followed by a tone.
2. After the tone, say “Re-dial”. The
system responds with “Re-dial
using <phone name>” and dials
the last number called from the
connected Bluetooth phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
.
Press b g and begin speaking
to answer the call.
.
Press c ª to ignore a call.
Call Waiting
Call waiting must be supported on
the Bluetooth phone and enabled by
the wireless service carrier to work.
.
Press b g to answer an
incoming call when another call
is active. The original call is
placed on hold.
.
Press b g again to return to the
original call.
.
To ignore the incoming call,
continue with the original call
with no action.
.
Press c ª to disconnect the
current call and switch to the call
on hold.