Filter
Top Products
Once two remote starts or a single start with a time
extension have been used, the vehicle must be started
with the keyless access ignition control knob before
you can use the remote start feature again.
The remote start feature will not operate if any of the
following occur:
• The ignition is in any position other than LOCK/OFF.
• A keyless access transmitter is inside the vehicle.
• The hood is open.
• There is an emission control system malfunction.
• The remote start feature is not enabled. See
“Remote Start” under DIC Vehicle Customization on
page 3-68.
The engine will turn off during a remote vehicle start if
the coolant temperature gets too high, or the oil pressure
is too low.
Your vehicle was shipped from the factory with the
remote vehicle start system enabled. The system may
be disabled through the Driver Information Center (DIC).
See “Remote Start” under DIC Vehicle Customization
on page 3-68 for additional information.
See Engine Exhaust on page 2-47 for important safety
information when using remote start in a closed
garage.
Remote Start Ready
If your vehicle does not have the remote vehicle start
feature, it may have the remote start ready feature. This
feature allows your dealer/retailer to add the
manufacturer’s remote vehicle start feature. See your
dealer/retailer if you would like to add the manufacturer’s
remote vehicle start feature to your vehicle.
2-16