Filter
Top Products
Button And Automatic (Key Access default): If the
features are enabled though the Easy Exit Setup menu,
the driver’s seat will move back, and if the vehicle
has the power tilt wheel and telescopic steering feature,
the power steering column will move up and forward
when the key is removed from the ignition or after
pressing the easy exit seat button. The automatic easy
exit seat movement will only occur one time after
the key is removed from the ignition. If the automatic
movement has already occurred, and you put the
key back in the ignition and remove it again, the seat
and steering column will stay in the original exit position,
unless a memory recall took place prior to removing
the key again.
No Change: No change will be made to this feature.
The current setting will remain.
To select a setting, press the set/reset button while the
desired setting is displayed on the DIC.
Easy Exit Setup
If your vehicle has this feature, it allows you to select
which areas will recall with the automatic easy exit seat
feature. It also allows you to turn off the automatic
easy exit feature. See Memory Seat and Mirrors
on page 1-6 and “Easy Exit Recall” earlier for more
information.
Press the customization button until Easy Exit Setup
appears on the DIC display. Press the set/reset button
once to access the settings for this feature. Then
press the menu up/down button to scroll through the
following settings:
Off: No automatic seat exit will recall.
Seat Only: The driver’s seat will recall.
Tilt Only: The steering wheel tilt feature will recall.
Telescope Only: The steering column telescope
feature will recall.
Seat/Tilt: The driver’s seat and the steering wheel tilt
feature will recall.
Seat/Telescope: The driver’s seat and the steering
column telescope feature will recall.
Tilt/Telescope: The steering wheel tilt and steering
column telescope features will recall.
All (default): The driver’s seat and the steering wheel
tilt and steering column telescope features will recall,
if your vehicle has this option.
No Change: No change will be made to this feature.
The current setting will remain.
To select a setting, press the set/reset button while the
desired setting is displayed on the DIC.
3-77